Page 1 of 1
correct values
Posted: Sat May 24, 2025 6:19 pm
by radium98
Hello folks .
wich are the correct values for the rds filter LC .
after online formula all wrongs .

Re: correct values
Posted: Sun May 25, 2025 3:44 am
by Albert H
I make it about 350µH to get 57kHz with a 22n capacitor.
My filter uses a 1mH inductor in parallel with a 6n8 and a 1n capacitor which comes out very close to 57kHz.
Re: correct values
Posted: Sun May 25, 2025 6:34 am
by radium98
@Albert H , thanks for thoses replies , but 1mH with 6n8 give me 61.033 khz , it is a pass band filter , wich online calculator , you used .
Re: correct values
Posted: Mon May 26, 2025 1:44 am
by Albert H
I didn't. I used
Res Formula.jpg
where F is frequency in Hz, 2pi is 6.283, L is inductance in Henries, and C is capacitance in Farads
You missed the
1n in parallel with the
6n8, which gives you
7n8. So the tuned circuit is (effectively) 1mH in parallel with 7.8nF. With these values, the resonant frequency works out at 56.987 kHz, which is certainly close enough to 57 kHz!
Re: correct values
Posted: Mon May 26, 2025 2:19 am
by Albert H
Like this:
Res Circuit 57kHz.jpg
Re: correct values
Posted: Mon May 26, 2025 7:31 am
by radium98
Thanks a lot Albert H