Thanks for the info...nrgkits.nz wrote: ↑Fri Jul 31, 2020 11:40 amNot quite 0% but close enough, it will got from about 50mW up to 10W. You could bring out three cables if you wanted, however you would first need to de-solder the SMT trimpot and then solder your three cables to the tiny solder pads. It's DC controlled. I would recommend just leaving it as it.BriansBrain wrote: ↑Mon Jul 27, 2020 1:05 pmA bit more info please
Can it go from 0 - 100% ?
Instead of the trimmer could I bring out three cables from the board to an external pot (is it DC controlled) ?
Everything technical about radio can be discussed here, whether it's transmitting or receiving. Guides, charts, diagrams, etc. are all welcome.
- no manz can test innit
- Posts: 189
- Joined: Sat Jun 08, 2019 1:22 pm
- Location: Gran Canaria, Spain. One of the 7 islands off the N.W. coast of Africa.
''Radio Brian'' - One of the Most Unique English Speaking Radio Stations in the Canaries... Possibly the World.
- proppa neck!
- Posts: 508
- Joined: Sun Sep 07, 2014 4:20 pm
That looks mint, Gareth.nrgkits.nz wrote: ↑Fri Jul 24, 2020 2:17 pmHere’s my new exciter, this will beat the pcs exciters by far - no in band noise and harmonics are -70dBc. Phase noise -115dBc/Hz at 10KHz offset.
PLL reference is a TCXO temperature compensated
Power output is 10W variable, this provides enough drive for multiple pallets combined together for big power.
LCD will also give you the forward and reverser power, swr, and also the deviation.
Modulation is DC coupled and is linear and flat from 30Hz to 57KHz.