Post
by BriansBrain » Fri Jul 31, 2020 1:32 pm
nrgkits.nz wrote: ↑Fri Jul 31, 2020 11:40 am
BriansBrain wrote: ↑Mon Jul 27, 2020 1:05 pm
nrgkits.nz wrote: ↑Fri Jul 24, 2020 11:35 pm
The output power is set using an onboard trimmer.
A bit more info please
Can it go from 0 - 100% ?
Instead of the trimmer could I bring out three cables from the board to an external pot (is it DC controlled) ?
Thanks
Not quite 0% but close enough, it will got from about 50mW up to 10W. You could bring out three cables if you wanted, however you would first need to de-solder the SMT trimpot and then solder your three cables to the tiny solder pads. It's DC controlled. I would recommend just leaving it as it.
Thanks for the info...

''Radio Brian'' - One of the Most Unique English Speaking Radio Stations in the Canaries... Possibly the World.