10Ghz Microwave Link Receiver Box STL X Band Satcan

garna86 · Post by **garna86** » Fri Oct 02, 2015 5:29 pm

picked this receiver up recently does this look any to you guys?

teckniqs · Post by **teckniqs** » Sat Oct 03, 2015 12:26 pm

The voltage drop resistor looks a bit burnt out, could do with a 5v regulator instead.

garna86 · Post by **garna86** » Sun Oct 04, 2015 9:06 am

thanks for the quick reply mate, how should i go about fixing the resistor

teckniqs · Post by **teckniqs** » Sun Oct 04, 2015 12:15 pm

Remove it and use a 7805 regulator instead. Where the red power wire goes on to the sat can, put your regulator + input on to there and your 5v + output to where the resistor was connected to. Obviously the regulator needs to be connected to ground too.

garna86 · Post by **garna86** » Mon Oct 05, 2015 1:41 pm

ok wicked mate i will get a new regulator and give it a go

10Ghz Microwave Link Receiver Box STL X Band Satcan

10Ghz Microwave Link Receiver Box STL X Band Satcan

Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan

Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan

Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan

Re: 10Ghz Microwave Link Receiver Box STL X Band Satcan