One of us needs to pull out the tree fiddy and get one of these:
https://www.hf-electronics.nl/Uni-Eindt ... 5-MRF101AN
Chinese 15W Amp
-
Bton-FM
- tower block dreamin
- Posts: 463
- Joined: Sun Jun 16, 2019 2:55 pm
- Location: Beside the seaside
Re: Chinese 15W Amp
Perhaps you could just copy it from the picture. The circuit isn't that complicated: It's just a bias circuit and impedance matching.yellowbeard wrote: ↑Mon Dec 06, 2021 5:15 pm One of us needs to pull out the tree fiddy and get one of these:
https://www.hf-electronics.nl/Uni-Eindt ... 5-MRF101AN
The matching for the MRF101 is taken from the circuit in the datasheet.
-
reverend
- no manz can test innit
- Posts: 235
- Joined: Sat Jul 25, 2020 12:03 pm
Re: Chinese 15W Amp
That's OK but it needs component values calculating depending on the use. You could make something similar with squares of PCB cut out and stuck onto a single-sided copper clad PCB (which is exactly what I used to do in the old days). It would be good to have some of the input component matching etched onto the board, but this might not be difficult with too wide a range of transistors due to the different input impedances (it might just be possible to use additional padding capacitors/resistors on the input of the transistor to make them all the same). The output match is going to change massively with supply voltage / output power so these would have to be calculated seperately for each device.yellowbeard wrote: ↑Mon Dec 06, 2021 5:15 pm One of us needs to pull out the tree fiddy and get one of these:
https://www.hf-electronics.nl/Uni-Eindt ... 5-MRF101AN
Lots to think about!
if it ain't broke, keep tweaking
-
jvok
- no manz can test innit
- Posts: 220
- Joined: Sun Aug 16, 2020 2:44 pm
Re: Chinese 15W Amp
Looks like that hf-electronics.nl link is only for a blank PCB so you'd probably have to design your own matching circuit anyway. They say they have a schematic for the MRF101 but as Bton said that's probably just the one off the datasheet. And for the RD06 and RD15 you're on your own.
NXP have a complete reference design for the MRF101 for FM band (and other frequencies too). Look under Design Resources at the bottom of the page: https://www.nxp.com/products/radio-freq ... AN-REFCirc Annoyingly you have to sign up before they let you download the zip file but it does have the full layout and BoM. No schematic for some reason but the boards simple enough you can trace it out pretty easily.
NXP have a complete reference design for the MRF101 for FM band (and other frequencies too). Look under Design Resources at the bottom of the page: https://www.nxp.com/products/radio-freq ... AN-REFCirc Annoyingly you have to sign up before they let you download the zip file but it does have the full layout and BoM. No schematic for some reason but the boards simple enough you can trace it out pretty easily.