Everything technical about radio can be discussed here, whether it's transmitting or receiving. Guides, charts, diagrams, etc. are all welcome.
6 posts • Page 1 of 1
- who u callin ne guy bruv
- Posts: 12
- Joined: Fri Nov 29, 2019 10:10 pm
And what would be the point of that easy to take top off and have a look inside and check the amp stage and exciter been looking at a few exciters and amps and going to put a couple together for my owe use
Been there done it and about to do it again
- Posts: 251
- Joined: Fri Oct 17, 2014 10:35 am
I get all mine done at a local sheetmetal factory, they pre punch all the holes and cut out any shapes required eg for mains IEC inlets. They use FabriWin and the files are exported and uploaded to the Armada CNC machines over serial cable.