badly need help
-
- proppa neck!
- Posts: 939
- Joined: Fri Aug 26, 2016 7:01 pm
badly need help
HI all
well i am experimenting some problem with the project i did
it is a bout a pll that only can control a tsa511 the board only have the controller ic 16f628a with hex inside that go 87 to 109mhz and also can have power in percent .
my problem is the pll start up show some extra characters as the youtube video show of my project and also i have no control i tried linkig to an rdvv transmitter that work ok .
So if any can help me out with the correct hex for it if anyone have
this project was badly and hardly found on the net and it was made by vincent bruinink
regards
- yellowbeard
- tower block dreamin
- Posts: 318
- Joined: Wed Jul 08, 2015 5:40 am
Re: badly need help
There are some versions of that software on viproje - don't know if they have the version you need, and the text is in Turkish - best o luck!
Code: Select all
http://www.viproje.net/
-
- proppa neck!
- Posts: 939
- Joined: Fri Aug 26, 2016 7:01 pm
Re: badly need help
Thank you yellow heard but not this I knew it before site of Hussein BTW thanks for the time looking in
-
- big in da game.. trust
- Posts: 97
- Joined: Tue Mar 07, 2017 8:57 pm
Re: badly need help
Try opening the hex file with a programmer like ICPROG, it will let you edit the bytes in the EEPROM. Just do some experiments.
Also you can try MPLAB disassembly view: enter the PIC target model, import the .Hex and it will show the code it came from (but without meaningful labels and no comments!).
Also you can try MPLAB disassembly view: enter the PIC target model, import the .Hex and it will show the code it came from (but without meaningful labels and no comments!).
-
- proppa neck!
- Posts: 939
- Joined: Fri Aug 26, 2016 7:01 pm
Re: badly need help
Krakatoa i will try by tomorrow and let you know thanks