Got a new tuner, onkyo T-4970

Everything technical about radio can be discussed here, whether it's transmitting or receiving. Guides, charts, diagrams, etc. are all welcome.
Post Reply
Fil
who u callin ne guy bruv
who u callin ne guy bruv
Posts: 16
Joined: Mon Jun 18, 2018 10:52 pm

Got a new tuner, onkyo T-4970

Post by Fil » Tue Jul 10, 2018 4:59 pm

Been using my pioneer recievers built in radio, its ok, but was looking for an old technics seperate i used to have, may have binned when I moved several years ago, so searching the net and came across info about an Onkyo T-4970, and after a bit of waiting, got one from france via good old ebay. Think they were only ever sold in Germany

It seems to be pulling in the weaker stations a lot clearer, and sounds better too!

Stuff looked so nice in the early 90s, build 93 to 95

Image

And before I got it, again since living here, ive been using some old home made FM antenna, someone left in the loft, so I finaly got round to sticking a good old Dipole rod up outside.

Image
Just a listener since 1990 based in RM13 ;)

User avatar
radionortheast
tower block dreamin
tower block dreamin
Posts: 474
Joined: Wed Sep 09, 2015 1:38 pm

Re: Got a new tuner, onkyo T-4970

Post by radionortheast » Wed Aug 22, 2018 6:27 pm

Old tuners are quite good, i’ve had afew i’m bought that I experimented with trying to get the best reception putting 110khz filters in them, (because they where tuners that didn’t have anyway to switch to a different bandwidth). You do get less distortion and more selectivity with a car radio with dsp chip in, theres nothing to mess about with or ajust.

Old tuners are better than one of those cheap sdr sticks you plug into your computer that overload easly, you can get images with strong signals, with tweaking its possible to get them down, the more if stages the more it tends to better..

Albert H
proppa neck!
proppa neck!
Posts: 2737
Joined: Tue Apr 05, 2016 1:23 am

Re: Got a new tuner, onkyo T-4970

Post by Albert H » Thu Aug 23, 2018 2:12 am

I've been playing around with some of the cheap SDR stick, and found one from DX.com for about $11 that works really well. I take the PCB out of the cheap plastic box, and rehouse it in a small diecast box, with the appropriate connectors for aerial, baseband output, power and logic control. I usually add a remotely variable attenuator which improves the image rejection in the presence of strong signals. I've written some drivers for a couple of the SDR chips, and they're actually really interesting to mess around with.

I have a couple of these receivers used for spot frequency monitoring (in one case listening to a certain 70cm repeater) - they're cheap enough for this, and I use one for marine band monitoring, scanning through the popular channels, and stopping when a signal is received.

My current experiment is to use one on HF, with a variable gain, critically tuned preamplifier (tuned and gain adjusted by the control logic), and the results are certainly promising. It may be possible to build a comprehensive multi-mode communications receiver that tunes from close to DC right up to the microwaves, including on-board data mode decryption and morse decoding, for about £80 including the Raspberry Pi to control it!
"Why is my rig humming?"
"Because it doesn't know the words!"
;)

Post Reply